Or are you suggesting paint the entire furniture or did you mean use the gripping primmer and the stain. With that stated – a primer is never a bad factor.
The most likely is the stain wasn’t blended properly sufficient or was applied in too thick coats. The other thing that could have occurred is the floor was not the same smoothness all over. It could have been sanded extra in one area and not the opposite or there could possibly be dirty in some sections and the paint adhered another way. Many of them include waxes or varnish. If you rub your piece with a tad too much drive , it can cause inconsistencies in your utilized finish and you’ll have to start out over with a good sanding. I’ve seen this enough occasions to not use them at all. First sand, then use a gripping or bonding primer first.
I wish to stain my espresso desk black and this may work. However, there’s a broken place the place I had positioned recent flowers and the moisture damaged the finish. The table is stained oak and I do choose stain over paint. If you had the identical stain that was initially used, then touching up can be the best way to go.
It could have nothing to do with the product and extra about the the way it was applied. Was it stirred well, utilized in skinny even coats? If you prep the surface, stir the paint nicely, and apply light even coats you’ll get an excellent end.
Since you are not distressing -you could use a gripping primer after sanding. Glidden Gripper is certainly one of my go to primers. Get it mixed to a gray formulation – don’t use white. It will be too onerous to cover with black. It sounds like you haven’t given up on the piece – with sanding and a few more effort you just might provide you with one great looking piece. This has occurred to me more than once when I paint something.
